Led strip H.E. 96W 12.500lm 24V IP20 PCB 10mm Coil 1050 SMD 2835

DESCRIPTION
Led Strip with Led Chip 2835 High Luminous Efficiency of 130 Lumen per Watt (130 Lm / W)
Supply voltage DC 24V (Power supply not included)
Led Strip Dimmable and Cuttable to every 7 Led (33.33mm)
Nominal Power 96W per coil / Power Consumption 19.2W / mt
Nominal Lumen 1.050 Lm per Coil / Effective Lumen 210 Lm / mt
Led strip 2835 of 5 meters, mounted on 3M double-sided tape.
Consisting of 210 LEDs / m, (1050 total LEDs over 5 meters).

DATA SHEET
• Model HE105096
• Code 5974, 5973, 5972, 5971
• PCB width 10mm
• PCB + SMD height 1.5mm
• Coil length 5mt
• DC 24V power supply
• Nominal Power 96W
• Effective power 19.2W / mt
• Nominal Lumen 12.500lm
• Effective Lumens 2500lm / mt
• Kelvin 2700K / 3000K / 4000K / 6500K
• Color rendering (CRI) 80+
• Led type 2835 x 1050pcs
• Cuttable Every 7 Led / 33.33mm
• IP20 waterproofing
• Dimmable YES
• Operating temperature -20 ° to + 40 ° degrees
• CE / RoHS / TUV certifications
• 3 Years Warranty
 
The connection of several Led strips must be carried out in parallel.
For installation it is necessary to use aluminum profiles for dissipation.

————————————————————————————————————————
CORRECT INSTALLATION - ALUMINUM PROFILES
To ensure maximum performance in terms of light output and duration, installation on a special aluminum profile is mandatory, designed for correct heat dissipation.
The aluminum profiles not only dissipate heat, but also protect the LED strips from dust, insects and partially moisture.
 
PROPER NUTRITION
The LED strips must be powered with a constant voltage power supply, usually with the DC symbol.
With a power that is equal to or greater than the consumption of the length required for installation.
The 24V HE105096 Led Strip with a consumption of 96W for 5 meters requires a DC 24V power supply with a Wattage of 100W or higher.
The voltage drop can affect the length of the installed LED strip ... normally it is recommended to install a maximum of 10 meters for each continuous line.
To reach greater lengths, it is mandatory to power the Led Strip at both ends or at each 5m section.
  
DIMMERATION
To adjust the light intensity of a LED strip, it is necessary to use a receiver that acts as a controller with a PWM signal.
Control modes vary by device type.
You can dim the Led strips with a Wi-Fi controller, from Pushbutton, use Alexa's voice control, remotely manage via Smartphone and even set a timer.