Switch with Proximity Sensor 12-24DC 4A for switching on the passage of the hand for aluminum profile led strips

Switch with proximity sensor for led strips to turn your led strip on and off with the passage of the hand. Small size sensor that can be installed directly inside the aluminum profile.

Thanks to this proximity sensor, with the passage of the hand over the sensor the led strip will light up gradually (with a distance of less than 8cm). To turn off the LED strip or the LED bar, simply pass your hand near the sensor again.

This sensor has a 12-24V DC output voltage and supports a maximum output current of 4A and a maximum power of 96W at 24V (48W at 12V).

It is equipped with a 3M adhesive for a simple, quick and safe installation. This will also make it very stable.

It can also be used for table or bedside lamps or for installation inside furniture and wardrobes.

INSTALLATION INSTRUCTIONS:

The sensor must be installed between the power supply and the led strip. This procedure must be done with the led strip off.
Thanks to the cables already soldered on the switch / sensor, installing it will be really simple: just connect the input cables to the power supply while the output cables to the LED strip, paying attention to the polarity.
Subsequently the switch with proximity switch must be fixed inside the profile.
Once fixed, you need to cut a 7x5mm hole on the pvc screen near the sensor.

TECHNICAL FEATURES:

INPUT VOLTAGE: DC 12-24V
OUTPUT VOLTAGE: DC 12-24V
ANGLE: 15-30 °
DISTANCE: less than 8cm
OPERATING TEMPERATURE: -30 ° C ∼ + 55 ° C
CERTIFICATIONS: EMC, RoHS
WARRANTY: 5 Years
PROTECTIONS: Polarity inversion