Switch and Dimmer with Proximity Sensor 12-24DC 8A for Hand Switching for DS02 LED Strips

Switch and dimmer with proximity sensor for LED strips to switch your LED strip on and off as your hand passes. Small sensor that can be installed directly inside the aluminium profile. With this LED strip dimmer you can adjust the light intensity while keeping your hand still in front of the sensor.

Thanks to this proximity sensor, with the passage of the hand over the sensor the led strip will gradually switch on (with a distance of less than 8cm). To switch off the led strip or led bar, simply pass your hand over the sensor again.

This sensor has an output voltage of DC 9-25V and supports a maximum output current of 8A.

It comes with a 3M adhesive for easy, quick and safe installation. This will also make it very stable.

It can also be used for table or bedside lamps or for installation inside furniture and wardrobes.

INSTALLATION INSTRUCTIONS:

The sensor should be installed between the power supply and the LED strip. This should be done with the LED strip switched off.

Thanks to the cables already soldered on the switch/sensor installation will be really simple: just connect the input cables to the power supply and the output cables to the led strip, paying attention to the polarity.

Afterwards the switch with proximity switch should be fixed inside the profile.

TECHNICAL FEATURES:

INPUT VOLTAGE: DC 12-24V

OUTPUT VOLTAGE: DC 12-24V 

DISTANCE: less than 4 cm

OPERATING TEMPERATURE: -30°C ∼ +55°C

CERTIFICATIONS: EMC, RoHS

DIMENSIONS: 9 x 9 x 44 mm