Polystyrene frame for indirect LED lighting K14122 100 cm - Bidirectional light effect

Polystyrene frame for indirect lighting with LED strip housing to reproduce in a simple, practical and above all economical way, elegant and refined bidirectional light effects through indirect lighting.

Thanks to the design of this frame you can illuminate your walls with a bidirectional effect by installing a double LED strip. Try installing a single-colour LED strip and an RGB LED strip to recreate incredible lighting effects.

Our decorative compact polystyrene mouldings are made of D30 high-density expanded polystyrene, with well-finished details and edges. They are fully customisable, easy to cut to suit your needs, and can also be plastered and painted. 

It is also possible to install them outdoors.

The installation of decorative frames is simple and practical for all DIY enthusiasts and do-it-yourselfers, even the less experienced. They can be installed using a special adhesive (not included) and therefore do not require the use of dowels and screws.

The LED strip should always be installed inside an aluminium profile to dissipate heat. The profile must then be installed inside the polystyrene frame. It is therefore not possible to fix the LED strip directly onto the surface of the frame as the LED strip would be damaged in a short time due to overheating, which would invalidate the warranty of the LED strip.

The aluminium profile, LED strip and glue for installation are not included!

DATA SHEET:

Bezel length: 1000mm

Dimensions: 125mm x 60mm

Profile slot for LED strip: 20mm / 25mm

Installation: Ceiling angle

Bi-directional light: Yes

Paintable: Yes

Stuccoable: Yes

Can be installed outdoors: Yes

Material: High Density Polystyrene D30